| Number |
Problem |
Reason |
Method |
| 1 |
The palm form stops suddenly during running. |
The palm form or conveyor chain has been blocked. |
Check the guide rail and gear of conveyor chain |
| 2 |
The conveyor chain does not run or runs slowly. |
The tension of conveyor chain is too hard |
Adjust the double head screw so that the tenacity is proper.(Must
be done under cool condition) |
| 3 |
Single air switch cannot be pressed down. |
The frequency inverter has not finished discharging. |
Renew the machine after shutting off the power supply and
the frequency transformer has finished discharging. |
| 4 |
The glove or PVC dot is being blackened. |
The temperature is too high. |
Adjust the temperature meter to reduce the temperature. |
| 5 |
Temperature in the over unevenly or the temperature is sufficient. |
Part of quartz infra-red heating tubes has been burnt. |
Change the same heating tubes. |
| 6 |
The air tank does not run. |
The air pressure is not enough. |
Raise the air pressure. |
| The program is wrong. |
Turn "Select Switch "to "Reset" then
to "AUTO" |
| 7 |
The positioning is not correct. |
The voltage is not stable resulting in an abnormal motor
speed. |
Add a stabilizer tube in the drive section. |
